Operation Manual

Switching On Your Steam Cleaner

Insert the electrical plug into the wall socket and press down on the power switch

and boiler switch to turn the appliance on.

The light integrated into the power switch and the boiler switch will illuminate orange.

The appliance will heat up and produce steam.

Heating time is approximately 8 minutes when cold water is used.

The green “Steam Ready” indicator light turns on when steam has been produced

and the appliance is ready to be used.

Once the appliance is switched on and the green “Steam Ready” light illuminates solid

green, the green steam ready light will then uctuate on and off during operation, in

order to maintain constant steam temperature and pressure. The green steam ready

light uctuating on and off during use is normal, it is not a fault in the appliance. The

steam cleaner can continue to be used as the green ready light uctuates on and off.

NOTE: Do not switch the steam cleaner on if there is no water in the water tank.

CAUTION: Read the instructions for “Filling your Steam Cleaner With Water” (below)

before using the appliance.

CAUTION: Always unplug the appliance before lling with water.

IMPORTANT: Do not add cleaning solutions, scented perfumes, oils or any other che-

micals to the water used in this appliance. Use only tap water or if the tap water in

your area is very hard use distilled / puried / dimineralised water.

Filling Your Steam Cleaner With Water

Step 1: Before lling the steam cleaner, remove the electrical plug from the wall socket.

Step 2: Open water tank cap.

Step 3: Use the funnel to add 1.35L of water or ll until the water tank is full. Close the

water tank cap.

Step 4: Plug the appliance into a standard 240volt wall socket and switch on the

appliance as per instructions above.

Step 5: Allow approximately 8 minutes for steam to reach its working temperature and

pressure. The green “Steam Ready” indicator light will illuminate when the appliance

is ready to be used.

NB: once the green “Steam Ready” light illuminates solid green, the green steam

ready light will then uctuate on and off during operation, in order to maintain con-

stant steam temperature and pressure. The green steam ready light uctuating on

and off during use is normal, it is not a fault in the appliance. The steam cleaner can

continue to be used as the green ready light uctuates on and off.

Step 6: Connect desired attachments onto the exible Steam Hose.

Step 7: Each time the unit is used , some water may come out from the nozzle of the

hose or attachments . This is unheated condensed water in the hose left over from

the previous time. This is normal, simple drain any condensed water from the hose

and use as normal.

OPERATING INSTRUCTION