Operation Manual

Switching On Your Steam Cleaner

Insert the electrical plug into the wall socket and press down on the power switch

and boiler switch to turn the appliance on.

The light integrated into the power switch and the boiler switch will illuminate.

The appliance will heat up and produce steam.

Heating time is approximately 8 minutes when cold water is used.

The green “Steam Ready” indicator light turns on when steam has been produced

and the appliance is ready to be used.

Once the appliance is switched on and the green “Steam Ready” light illuminates solid

green, the green steam ready light will then uctuate on and off during operation, in

order to maintain constant steam temperature and pressure. The green steam ready

light uctuating on and off during use is normal, it is not a fault in the appliance. The

steam cleaner can continue to be used as the green ready light uctuates on and off.

NOTE: Do not switch the steam cleaner on if there is no water in the water tank.

CAUTION: Read the instructions for “Filling your Steam Cleaner With Water” (below)

before using the appliance.

CAUTION: Always unplug the appliance before lling with water.

IMPORTANT: Do not add cleaning solutions, scented perfumes, oils or any other

chemicals to the water used in this appliance. Use only tap water or if the tap water

in your area is very hard use distilled / puried / dimineralised water.

Filling Your Steam Cleaner With Water

Step 1: Before lling the steam cleaner, remove the plug from the wall socket.

Step 2: Turn Safety/Filler Cap counter clockwise until removed.

Step 3: Use a relling Bottle and funnel to add 1.5L of water. Do not overll. Replace

Safety/Filler Cap by turning clockwise.

Step 4: Plug the unit into a standard 240volt wall socket and switch the appliance on

as per the instructions above.

Step 5: Allow approximately 8 minutes for steam to reach its working temperature and

pressure. The green “Steam Ready” indicator light will illuminate.

NB: Once the appliance is switched on and the green “Steam Ready” light illuminates

solid green, the green steam ready light will then uctuate on and off during operation,

in order to maintain constant steam temperature and pressure. The green steam ready

light uctuating on and off during use is normal, it is not a fault in the appliance. The

steam cleaner can continue to be used as the green ready light uctuates on and off.

Step 6: Connect desired attachments onto the Flexible Steam Hose.

Step 7: Each time the unit is used, some water may come out from the nozzle of the

hose or the attachments. This is unheated condensed water in the hose left over from

the previous time. This is normal, simply drain any condensed water from the hose

and use as normal.

OPERATING INSTRUCTION