Operation Manual
Before Use
8
Before Use
D. Filling Boiler with Water
WARNINGS:
•
Carefully read all instructions before removing Boiler Cap.
•
Always unplug appliance before lling the Boiler.
Follow these instructions to avoid overlling the
Boiler.
• Be sure appliance is unplugged, and has
cooled for at least 5 minutes before lling with
water.
•
Make sure Handle Assembly is in the upright
“Off” position.
Remove Boiler Cap by pressing
it down and turning it counterclockwise.
• Pour in a maximum of 0.6 l / 20 oz. water using
the provided measuring cup. Make sure that
water does not overow.
Replace Boiler Cap
by pressing it down and turning it clockwise.
If using cold water, heating time is about 3-5
minutes. If using warm water, heating time is
reduced.
*IMPORTANT*
Use tap water – distilled or demineralized water is recommended
if tap water is too hard.
DO NOT add detergents, perfumes, oils or
other chemical substances.
*IMPORTANT*
• Do not overll the Boiler as excess water will be ushed out of the
Boiler before dry steam will emit.
• If re-lling the Boiler while Steamer has been in use, be sure to allow
Steamer to cool for at least 5 minutes and loosen Boiler Cap slowly
to allow any excess steam to escape before completely removing
Cap. (See step 2D, “Relling Boiler During Use” for detailed instruc-
tions.)