Installation Guide
THANK YOU
You’ve jus t
purchased a
li ghting product
designed and built
to provi de you
with many years
of enjoyment.
MERCI
Vous venez
d’acheter un
luminai r e conçu
pour vous donner
des années de
plai sir.
GRACI AS
Usted acaba de
adquiri r un
excelente
producto de
alumbrado
disenado y
construido para
7224-35
Instructions
• Pl ease re ad all instruct ions prior to i nstall ati on.
• Install ati on of this fixture must comply wi th local buil ding
codes.
• Install ati on of this fixture should be done by a quali fi ed
electrici an.
• Veuillez li re toutes les instructions avant l ’ i nstal lation.
• L’insta llation de ce lumi naire doit êtr e fai te selon le
code local de construc ti on.
• L’insta llation de ce lumi naire devrait être fai te par un
électrici en quali fié.
• Favor de leer todas las instruc ci ones antes de comenzar la
instalaci on.
• La instal acion de esta lumi nar i a (este producto) debera de
Tools Required • Outils Necessaire • Herramientas Requeridas
INSTALLATION & CONNECTIONS
1. Turn off power at main fuse box.
2. Mount cross bar (A) onto junct ion box using screws
(B)
3. Mount runni ng thread ni pple (C) to the cross bar (A)
and leave approximately 1” showing. Fasten using
locknut (D) and lockwasher (E).
4. Pull all electric al wire s from the power source
to wards the bottom of the crossbar. (Leave marettes on
wires until connection time)
5. Connect wire from power source to wi res from
fi xture. Black to black and white to whi te. Secure
connections with marettes (w i re connectors suppli ed).
6. Attach the ground wire (naked copper or green wire)
of the assembly to the green screw of cross bar or
bare green wire from power supply.
7. Tuck all connected wires back i nto the junc tion box.
8. Fasten backplate (F) to the wall by slid ing runni ng
thread ni pple (C) into centre hole of back plate.
9. Fasten whole assembly tightly usi ng finial (H).
10.Ins tall Halogen bulb 120V/150W T3 (78mm )
(inc luded).
Do not touch Bulb w ith bare hand, it will
shorten l amp l ife.
11.Ins tall glass shade (G) by sli ding ends of the glass
downwards onto the fixture back pl ate (F).
TURN ON POWER
ENJOY YOUR NEW Easylit e™ LIGHTING PRODUCT