Specifications

Operating System Setup 1 - 7
Quick Start Guide
1
Operating System Setup
If you are installing new system software, or are re-configuring your computer for a different system, make sure you
configure the appropriate OS setting in the BIOS before installing a new operating system.
1. Start-up the computer and press <F2> to enter the BIOS.
2. Go to the Advanced menu, select “Installed O/S” and make sure the appropriate operating system is selected.
3. Go to the Exit menu and select “Exit Saving Changes” (or press F10 and select “Yes” then press Enter) and
press Enter to exit the BIOS and reboot the computer.
Figure 1 - 2 - BIOS (Operating System Selection)
Main A
A
dvanced Security Boot Exit
F1 Help  Select Item -/+ Change Values F9 Setup Defaults
Esc Exit  Select Menu Enter Select Sub-Menu F10 Save and Exit
Item Specific Help
Advanced
Select options for
Advanced Chipset
features.
Phoenix SecureCore(tm) Setup Utility
Advanced Chipset Control
Installed O/S: [Vista]
SATA Mode Selection: [AHCI]
DFOROM(Robson) Support: [Enabled]
Reset Configuration Data: [No]
Boot-time Diagnostic Screen: [Disabled]
Legacy OS Boot: [Enabled]
Power On Boot Beep [Disabled]
Battery Low Alarm Beep: [Disabled]
FAN Control: [Automatic]