Specifications
Table Of Contents
- Manual
- Preface
- Chapter 1: Quick Start Guide
- Chapter 2: Storage Devices, Mouse, Audio & Printer
- Chapter 3: Power Management
- Chapter 4: Drivers & Utilities
- RAID & AHCI Setup
- What to Install
- Driver Installation
- Manual Driver Installation
- Updating/Reinstalling Individual Drivers
- User Account Control
- Windows Security Message
- New Hardware Found
- Driver Installation Procedure
- Chipset
- Video (VGA)
- LAN
- Card Reader
- TouchPad
- Hot Key
- USB 3.0
- MEI Driver
- Audio
- Optional Drivers
- PC Camera
- Wireless LAN
- Fingerprint Reader Module
- Bluetooth Module
- Chapter 5: BIOS Utilities
- Overview
- The Power-On Self Test (POST)
- The Setup Utility
- Main Menu
- System Time & Date (Main Menu)
- SATA Port # (Main Menu)
- System/Extended Memory (Main Menu)
- BIOS Revision/ KBC/EC firmware Revision / VGA Card etc. (Main Menu)
- Advanced Menu
- Advanced Chipset Control (Advanced Menu)
- Bluetooth Power Setting (Advanced Menu > Advanced Chipset Control)
- SATA Mode (Advanced Menu)
- Power On Boot Beep (Advanced Menu)
- Battery Low Alarm Beep (Advanced Menu)
- Launch PXE OpROM (Advanced Menu)
- Security Menu
- Set Supervisor Password (Security Menu)
- Set User Password (Security Menu)
- Password on boot (Security Menu)
- Trusted Computing (Security Menu)
- TPM State (Security Menu > TPM Support Enabled)
- Pending TPM operation (Security Menu > TPM Support & TPM State Enabled)
- Boot Menu
- Boot Option Priorities (Boot Menu)
- Save & Exit Menu
- Chapter 6: Upgrading The Computer
- Chapter 7: Modules
- Chapter 8: Troubleshooting
- Appendix A: Interface (Ports & Jacks)
- Appendix B: Control Center
- Appendix C: NVIDIA Video Driver Controls
- NVIDIA Video Driver Installation
- NVIDIA Control Panel
- Display Devices
- Display Modes
- Configuring an External Display (NVIDIA)
- Attaching Other Displays (Win 7)
- SLI Multi GPU Configuration
- SLI Multi GPU Configuration & Power
- Manage 3D Settings
- Adjust Video Settings
- HDMI Audio Configuration
- HDCP Status
- NVIDIA 3D Shutter Glasses Kit
- Stereoscopic 3D Hardware Setup
- Viewing Angles
- Set Up Stereoscopic 3D
- Appendix D: Specifications

III
Preface
FCC Statement
(Federal Communications Commission)
You are cautioned that changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not in-
stalled and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Re orient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the service representative or an experienced radio/TV technician for help.
Operation is subject to the following two conditions:
1. This device may not cause interference.
And
2. This device must accept any interference, including interference that may cause undesired operation of the
device.