Specifications
Table Of Contents
- Manual
- Preface
- Chapter 1: Quick Start Guide
- Chapter 2: Storage Devices, Mouse, Audio & Printer
- Chapter 3: Power Management
- Chapter 4: Drivers & Utilities
- RAID & AHCI Setup
- What to Install
- Driver Installation
- Manual Driver Installation
- Updating/Reinstalling Individual Drivers
- User Account Control
- Windows Security Message
- New Hardware Found
- Driver Installation Procedure
- Chipset
- Video (VGA)
- LAN
- Card Reader
- TouchPad
- Hot Key
- USB 3.0
- MEI Driver
- Audio
- Optional Drivers
- PC Camera
- Wireless LAN
- Fingerprint Reader Module
- Bluetooth Module
- Chapter 5: BIOS Utilities
- Overview
- The Power-On Self Test (POST)
- The Setup Utility
- Main Menu
- System Time & Date (Main Menu)
- SATA Port # (Main Menu)
- System/Extended Memory (Main Menu)
- BIOS Revision/ KBC/EC firmware Revision / VGA Card etc. (Main Menu)
- Advanced Menu
- Advanced Chipset Control (Advanced Menu)
- Bluetooth Power Setting (Advanced Menu > Advanced Chipset Control)
- SATA Mode (Advanced Menu)
- Power On Boot Beep (Advanced Menu)
- Battery Low Alarm Beep (Advanced Menu)
- Launch PXE OpROM (Advanced Menu)
- Security Menu
- Set Supervisor Password (Security Menu)
- Set User Password (Security Menu)
- Password on boot (Security Menu)
- Trusted Computing (Security Menu)
- TPM State (Security Menu > TPM Support Enabled)
- Pending TPM operation (Security Menu > TPM Support & TPM State Enabled)
- Boot Menu
- Boot Option Priorities (Boot Menu)
- Save & Exit Menu
- Chapter 6: Upgrading The Computer
- Chapter 7: Modules
- Chapter 8: Troubleshooting
- Appendix A: Interface (Ports & Jacks)
- Appendix B: Control Center
- Appendix C: NVIDIA Video Driver Controls
- NVIDIA Video Driver Installation
- NVIDIA Control Panel
- Display Devices
- Display Modes
- Configuring an External Display (NVIDIA)
- Attaching Other Displays (Win 7)
- SLI Multi GPU Configuration
- SLI Multi GPU Configuration & Power
- Manage 3D Settings
- Adjust Video Settings
- HDMI Audio Configuration
- HDCP Status
- NVIDIA 3D Shutter Glasses Kit
- Stereoscopic 3D Hardware Setup
- Viewing Angles
- Set Up Stereoscopic 3D
- Appendix D: Specifications

Modules
Fingerprint Reader Module 7 - 45
7
AuthenTec TrueSuite Application
The AuthenTec TrueSuite application is used in conjunction with your fingerprint
reader to enroll fingerprints and manage settings etc.
User Enrollment
1. Click Start > All Programs > AuthenTec TrueSuite.
2. Click Yes when you have identified your fingerprint sensor ( Fingerprint
Reader Module in Figure 1 - 2 on page 1 - 6).
3. Click Yes when you are ready to enroll your fingerprints.
4. Click on the fingerprint diagram to select any finger to enroll.
5. You will be required to enter your Windows password (you will be prompted to
create a password if you have not already done so) at this point (click OK to
confirm the password entry).
6. Swipe the finger until the progress bar reaches 100% to enroll that finger.
Fingerprint
Enrollment
Note that it is strongly rec-
ommended that you enroll
more than one finger in
case of injury etc.
Figure 7 - 27
Fingerprint
Enrollment
8