Specifications

BIOS Utilities
Advanced Menu 5 - 9
5
Bluetooth Power Setting (Advanced Menu > Advanced Chipset Control)
You can adjust the Bluetooth module power setting to your preference. The default
setting (Disabled) will see the Bluetooth module powered off when the system is
started up or restarted. Enabling the power setting will have the module retain the
last power status (on or off) before any restart or shut down.
SATA Mode (Advanced Menu)
You can configure SATA (Serial ATA) control to operate in either AHCI (Ad-
vanced Host Controller Interface) or RAID (Redundant Array of Independent
Disks) modes from this menu. The SATA mode should be set BEFORE installing
an operating system, and after you have backed up all necessary files and data (see
sidebar). See “Setting Up SATA RAID Mode” on page 7 - 2 for details if you are
configuring you hard disks in a RAID.
Power On Boot Beep (Advanced Menu)
Use this menu item to enable/disable the beep as the computer starts up.
Battery Low Alarm Beep (Advanced Menu)
Use this menu item to enable/disable the battery low alarm beep.
Launch PXE OpROM (Advanced Menu)
Use this menu item to enable/disable the Boot option for legacy network devices.
You may need to enable this item if you need to boot from a network system (consult
your system administrator for details).

SATA Mode
Selection
Set the SATA mode BE-
FORE installing your
Windows 7 operating
system. Do not change
the mode unless you in-
tend to reinstall your op-
erating system, and
make sure you back up
all necessary files and
data before doing so.