Operating instructions

Upgrading The Computer

6 - 14 Upgrading the Hard Disk Drive/SSD

Removing the 2.5" (63.5mm) HDD or SSD

1. Remove the battery and rear cover (see pages 6 - 3 & 6 - 5).

2. The hard disk or solid state drive is located at point .

3. Remove screws & from the bracket (make sure you use a small manual

screwdriver and not an electrical screwdriver to do this, due to the delicate nature

of the screws).

4. Life the HDD assembly out of the computer.



Foam Insert for

SSDs

Note that if your comput-

er contains an SSD in

the bracket then a foam

insert will be supplied.

Make sure you have the

foam inserted when in-

stalling an SSD to this

bracket (see “Remov-

ing the SSD from the

Bracket.” on page 6 -

16).

Figure 6 - 12

2.5" HDD/SSD

Assembly Removal