Specifications
Table Of Contents
- Manual
- Preface
- Chapter 1: Quick Start Guide
- Overview
- Model Differences
- System Startup
- System Map: LCD Panel Open - Models A & B
- System Map: LCD Panel Open - Model C
- Keyboard - Models A & C
- Keyboard LED - Models A & C
- Keyboard - Model B
- Control Center
- System Map: Front & Rear Views
- System Map: Right View
- System Map: Left View
- System Map: Bottom View - Models A & B
- System Map: Bottom View - Model C
- Windows 7 Start Menu & Control Panel
- Video Features
- Power Options
- Chapter 2: Storage Devices, Mouse, & Audio
- Chapter 3: Power Management
- Chapter 4: Drivers & Utilities
- Chapter 5: BIOS Utilities
- Overview
- The Power-On Self Test (POST)
- The Setup Utility
- Main Menu
- Advanced Menu
- Advanced Chipset Control (Advanced Menu)
- Bluetooth Power Setting (Advanced Menu > Advanced Chipset Control)
- Intel(R) Rapid Start Technology (Advanced Menu)
- SATA Mode (Advanced Menu)
- Legacy USB Support (Advanced Menu)
- Boot Logo (Advanced Menu)
- Power On Boot Beep (Advanced Menu)
- Battery Low Alarm Beep (Advanced Menu)
- Security Menu
- Boot Menu
- Exit Menu
- Chapter 6: Upgrading The Computer
- Chapter 7: Modules
- Overview
- Setting Up SATA RAID or AHCI Mode
- Intel Rapid Storage Technology
- PC Camera Module
- Wireless LAN Module
- Intel® Wireless Display Application
- Fingerprint Reader Module
- Bluetooth Module
- 3rd Party Bluetooth Combo Driver Installation Information
- 3rd Party Bluetooth Combo Driver Version 1 Installation
- 3rd Party Bluetooth & WLAN Combo Settings
- 3rd Party Bluetooth Networking Setup
- 3rd Party Bluetooth & WLAN Combo Module Configuration
- Intel Bluetooth Combo Driver Installation
- Standard Bluetooth Configuration in Windows 7
- THX TruStudio Pro Audio
- Intel® Rapid Storage Technology Driver
- Intel® Rapid Start Technology Driver
- Chapter 8: Troubleshooting
- Appendix A: Interface (Ports & Jacks)
- Appendix B: Control Center
- Appendix C: Video Driver Controls
- Appendix D: Specifications

IV
Preface
FCC Statement
(Federal Communications Commission)
You are cautioned that changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not in-
stalled and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Re orient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the service representative or an experienced radio/TV technician for help.
Operation is subject to the following two conditions:
1. This device may not cause interference.
And
2. This device must accept any interference, including interference that may cause undesired operation of the
device.