Specifications
Table Of Contents
- Manual
- Preface
- Chapter 1: Quick Start Guide
- Overview
- Model Differences
- System Startup
- System Map: LCD Panel Open - Models A & B
- System Map: LCD Panel Open - Model C
- Keyboard - Models A & C
- Keyboard LED - Models A & C
- Keyboard - Model B
- Control Center
- System Map: Front & Rear Views
- System Map: Right View
- System Map: Left View
- System Map: Bottom View - Models A & B
- System Map: Bottom View - Model C
- Windows 7 Start Menu & Control Panel
- Video Features
- Power Options
- Chapter 2: Storage Devices, Mouse, & Audio
- Chapter 3: Power Management
- Chapter 4: Drivers & Utilities
- Chapter 5: BIOS Utilities
- Overview
- The Power-On Self Test (POST)
- The Setup Utility
- Main Menu
- Advanced Menu
- Advanced Chipset Control (Advanced Menu)
- Bluetooth Power Setting (Advanced Menu > Advanced Chipset Control)
- Intel(R) Rapid Start Technology (Advanced Menu)
- SATA Mode (Advanced Menu)
- Legacy USB Support (Advanced Menu)
- Boot Logo (Advanced Menu)
- Power On Boot Beep (Advanced Menu)
- Battery Low Alarm Beep (Advanced Menu)
- Security Menu
- Boot Menu
- Exit Menu
- Chapter 6: Upgrading The Computer
- Chapter 7: Modules
- Overview
- Setting Up SATA RAID or AHCI Mode
- Intel Rapid Storage Technology
- PC Camera Module
- Wireless LAN Module
- Intel® Wireless Display Application
- Fingerprint Reader Module
- Bluetooth Module
- 3rd Party Bluetooth Combo Driver Installation Information
- 3rd Party Bluetooth Combo Driver Version 1 Installation
- 3rd Party Bluetooth & WLAN Combo Settings
- 3rd Party Bluetooth Networking Setup
- 3rd Party Bluetooth & WLAN Combo Module Configuration
- Intel Bluetooth Combo Driver Installation
- Standard Bluetooth Configuration in Windows 7
- THX TruStudio Pro Audio
- Intel® Rapid Storage Technology Driver
- Intel® Rapid Start Technology Driver
- Chapter 8: Troubleshooting
- Appendix A: Interface (Ports & Jacks)
- Appendix B: Control Center
- Appendix C: Video Driver Controls
- Appendix D: Specifications

Video Driver Controls
Attaching Other Displays C - 7
C
Attaching Other Displays
If you prefer to use a monitor or flat panel display, connect it to the external monitor
port or HDMI-Out port on the left of the computer.
To Clone Displays:
1. Attach your display to the external monitor port or HDMI-Out port, and turn it on.
2. Go to the Intel(R) G&M control panel and click Display > Multiple Displays.
3. Click Operating Mode and select Clone Displays from the menu.
4. Click Apply, and OK to confirm the settings change.
5. You can switch the Primary/Secondary Display from the menu.
Multiple Display
At least one other dis-
play must be attached in
order to view Multiple
Display selection op-
tions.
General Settings
Click General Settings
to access settings the
options for any attached
display.
Figure C - 3
Display > Multiple
Displays (Clone)