Service manual

Disassembly

2 - 12 Removing the Hard Disk Drive

2.Disassembly

4. Take the HDD assembly out of the case.

5. Remove the screws -

and separate the HDD connector cable , and case .

6. Just reverse the removal procedure to install the new HDD assembly .

Jumper Setting for RAID/ATA Configuration

1. Turn off the computer, remove the battery (page 2 - 5) and hard disk (page 2 - 11).

2. Locate the jumper at point (Figure 8a).

3. Use a bent paper clip to push the switches up to ON for RAID mode, or down to off for ATA mode.

1 4 5 6



7. Hard Disk

•4 Screws

Figure 8

HDD Cable & Case

Removal

a. Remove the 4 screws.

b. Disconnect the HDD ca-

ble and lift the HDD as-

sembly out of the bay.



HDD System Warning

New HDD’s are blank. Before

you begin make sure:

You have backed up any data

you want to keep from your old

HDD.

You have all the CD-ROMs

and FDDs required to install

your operating system and

programs.

If you have access to the inter-

net, download the latest appli-

cation and hardware driver

updates for the operating sys-

tem you plan to install. Copy

these to a removable medium.

a. b.