Service manual

Disassembly

Removing the Hard Disk Drive 2 - 11

2.Disassembly

Removing the Hard Disk Drive

The hard disk drive(s) is (are) mounted in a removable case and can be taken out to accommodate other 2.5" IDE hard

disk drives with a height of 9.5mm (h). Follow your operating system’s installation instructions, and install all necessary

drivers and utilities (as outlined in Chapter 4 of the User’s Manual) when setting up a new hard disk.

Hard Disks in a RAID Configuration

If you are using two hard disks in a RAID configuration, the jumper on the mainboard needs to be set in order to configure

the hard disks in ATA or RAID mode.

Hard Disk Upgrade Process

1. Turn off the computer, remove the battery (page 2 - 5).

2. Remove screws

- (Figure 7a) from the hard disk cover , and remove the cover.

3. Remove screws - from the primary hard disk assembly (or - secondary hard disk assembly).

Figure 7

HDD Assembly

Removal

a. Remove the screws and

the HDD cover.

b. Remove the screws from

HDD assembly.



4. Hard Disk Cover

•9 Screws

1 3 4

5 7 8

1 2 3

5 8

6 7 9



Jumper Settings for

Multiple Hard Disk Use

If you are using more than

one hard disk in your

computer, make sure to

set the jumpers on all your

hard disks to the cable se-

lect option in order for the

system to recognize all the

disks (see your hard disk

manual or the information

printed on the hard disk it-

self for details on the jump-

er settings).