Service manual

Removing the HDD from its tray

1) Remove the HDD case from the computer (refer to Removing the HDD in Chapter

2 for details).

2) Remove the two sets of screws on the side of the case.

3) Slowly remove the HDD from the case until you see the connecting cable.

4) Gently disconnect the cable from the HDD being careful not to bend any pins or

crimp the cable.

5) Connect a new HDD

to the cable being

careful not to bend

any pins or crimp the

cable.

6) Slowly place the HDD

back into the case.

7) Hold the HDD firmly

in place with two

screws on each side.

8) Insert the HDD into

the computer (refer to

Inserting the HDD

in Chapter 2 for

details)

fastening screws

Inserting the HDD

1) Turn off the computer.

2) Turn the computer over.

3) Place the HDD case into the computer.

4) Slide the HDD in until you hear a click.

Removing the HDD from the notebook

1) Turn the computer off.

2) Turn the computer over.

3) Locate the HDD latch

4) Slide and hold the latch forward then slide

the HDD out of the computer.

5) Lift the hard disk drive out of the

computer.