Service manual
Table Of Contents
- Manual
- Preface
- 1: Introduction
- Overview
- System Specifications
- External Locator - Top View with LCD Panel Open
- External Locator - Front & Left Side Views
- External Locator - Right Side & Rear Views
- External Locator - Bottom View
- Mainboard Overview - Top (Key Parts)
- Mainboard Overview - Bottom (Key Parts)
- Mainboard Overview - Top (Connectors)
- Mainboard Overview - Bottom (Connectors)
- 2: Disassembly
- Overview
- Maintenance Tools
- Connections
- Maintenance Precautions
- Disassembly Steps
- Removing the Battery
- Removing the Hard Disk Drive
- Removing the Modem
- Removing the Wireless LAN
- Removing the System Memory (RAM)
- Removing the Optical (CD/DVD) Device
- Removing the Processor
- Removing the Keyboard
- Appendix A: Part Lists
- Appendix B: Schematic Diagrams
- System Block Diagram
- Socket 479 - 1 of 2
- Socket 479 - 2 of 2
- 855PM MCH-1
- 855PM MCH-2
- 855PM MCH-3
- DDRAM
- DDR Termination
- Clock Generator
- ICH4-1 (1 of 3)
- ICH4-2 (2 of 3)
- ICH4-3 (3 of 3)
- USB 2.0
- MDC, BT, CCD, Mini PCI
- HDD, CDROM
- LAN RTL8110S (B)-32
- LPC S I/O, Flash ROM
- Power On Checklist
- Hitachi H8S
- Audio Codec ALC202
- PCMCIA (PCI1620)
- PCMCIA Socket
- TI1394 (TSB43AB21)
- M10 AGP/PCI/Power
- M10 MEM I/F-A
- M10 MEM I/F-B
- M10 VGA Connector
- Panel CON
- VGA DDR DRAM Termination
- Audio Out & Off Board
- BTVCC, +1.5V, +1.8VS
- V_CORE
- +VDD3, +VDD5, +12V, +3V, +5V
- +2.5VS, +1.25VS, +5VS, +3VS
- Charger
- SMSC LPC47N217 LPC I/F
Disassembly
2 - 12 Removing the Optical (CD/DVD) Device
2.Disassembly
Removing the Optical (CD/DVD) Device
1. Turn off the computer, and remove the battery (page 2 - 5).
2. Remove screw at point (Figure 7a) and carefully lift up the optical device screw cover (Figure 7b).
3. Apply presure at point to push the optical device out of the computer (Figure 7c).
4. Insert the new device and carefully slide it into the computer (the device only fits one way. DO NOT FORCE IT; The
screw holes should line up.
5. Restart the computer to allow it to automatically detect the new device.
1 2
Figure 7
Optical Device
Removal
a. Remove the screws.
b. Carefully lift the cover off
the computer.
c. Push the optical device
out off the computer at
point 3.
3 4
1
a.
2
b.
c.
3
4
2. Optical Device
screw Cover
3. Optical Device
•1 Screw