Service manual
Table Of Contents
- Manual
- Preface
- 1: Introduction
- Overview
- System Specifications
- External Locator - Top View with LCD Panel Open
- External Locator - Front & Left Side Views
- External Locator - Right Side & Rear Views
- External Locator - Bottom View
- Mainboard Overview - Top (Key Parts)
- Mainboard Overview - Bottom (Key Parts)
- Mainboard Overview - Top (Connectors)
- Mainboard Overview - Bottom (Connectors)
- 2: Disassembly
- Overview
- Maintenance Tools
- Connections
- Maintenance Precautions
- Disassembly Steps
- Removing the Battery
- Removing the Hard Disk Drive
- Removing the Modem
- Removing the Wireless LAN
- Removing the System Memory (RAM)
- Removing the Optical (CD/DVD) Device
- Removing the Processor
- Removing the Keyboard
- Appendix A: Part Lists
- Appendix B: Schematic Diagrams
- System Block Diagram
- Socket 479 - 1 of 2
- Socket 479 - 2 of 2
- 855PM MCH-1
- 855PM MCH-2
- 855PM MCH-3
- DDRAM
- DDR Termination
- Clock Generator
- ICH4-1 (1 of 3)
- ICH4-2 (2 of 3)
- ICH4-3 (3 of 3)
- USB 2.0
- MDC, BT, CCD, Mini PCI
- HDD, CDROM
- LAN RTL8110S (B)-32
- LPC S I/O, Flash ROM
- Power On Checklist
- Hitachi H8S
- Audio Codec ALC202
- PCMCIA (PCI1620)
- PCMCIA Socket
- TI1394 (TSB43AB21)
- M10 AGP/PCI/Power
- M10 MEM I/F-A
- M10 MEM I/F-B
- M10 VGA Connector
- Panel CON
- VGA DDR DRAM Termination
- Audio Out & Off Board
- BTVCC, +1.5V, +1.8VS
- V_CORE
- +VDD3, +VDD5, +12V, +3V, +5V
- +2.5VS, +1.25VS, +5VS, +3VS
- Charger
- SMSC LPC47N217 LPC I/F
Disassembly
Removing the System Memory (RAM) 2 - 11
2.Disassembly
6. Pull the latches to release the second module if necessary.
7. Insert a new module holding it at about a 30° angle and fit the connectors firmly into the memory slot.
8. The module will only fit one way as defined by its pin alignment. Make sure the module is seated as far into the slot
as it will go. DO NOT FORCE IT; it should fit without much pressure.
9. Press the module down towards the mainboard until the slot levers click into place to secure the module.
10. Replace the memory socket cover and the 5 screws (see page 2 - 10).
11. Restart the computer to allow the BIOS to register the new memory configuration as it starts up.