User manual

2.6. Configuration
http://sksapps.com/sms/en/installation-configuration.html[2011/09/27 09:55:37]
2.6.1.1. Example configuration 1
This configuration is for a PS2 and PC connected directly with a crossover cable, or for
both connected to a network switch. There is no internet gateway device to connect to, so
the gateway is set to the IP address of the PC.
PS2
Settings
PS2 IP Address: 192.168.0.2
PS2 Subnet Mask: 255.255.255.0
PS2 Default Gateway: 192.168.0.1
mc0:/SYS-
CONF/IPCONFIG.DAT
PC
Settings
PC IP Address: 192.168.0.1
PC Subnet Mask: 255.255.255.0
PC Default Gateway: 192.168.0.1
2.6.1.2. Example configuration 2
Here is the configuration I use at home. Both PS2 and PC are on the same 192.168.2._
subnet, and my internet access point / router is at 192.168.2.1.
PS2
Settings
PS2 IP Address: 192.168.2.22
PS2 Subnet Mask: 255.255.255.0
PS2 Default Gateway: 192.168.2.1
mc0:/SYS-
CONF/IPCONFIG.DAT
PC
Settings
PC IP Address: 192.168.2.23
PC Subnet Mask: 255.255.255.0
PC Default Gateway: 192.168.2.1
Warning
If you are connected to the internet via the same network that you
are using to connect to your PS2 be very careful when you
change your PC's IP settings. You must make sure that your PC is
set to be on the same subnet as your access point/router (i.e. the
first three numbers of the PC IP address are the same as the
access point/router), and that the PC Default Gateway remains the
same (this will normally be the IP address of your access point.
Failure to do this may break your internet connection. If you are
not sure what you are doing, please make a note of your starting
settings by typing ipconfig /all at the command prompt.
2.6.2. General Configuration