Service manual

Disassembly
Removing the System Memory (RAM) - 2 2 - 11
2.Disassembly
Removing the System Memory (RAM) - 2
The computer has two memory sockets for 204 pin Small Outline Dual In-line Memory Modules (SO-DIMM) DDR III
(DDR3) supporting 1066/1333 MHz. The main memory can be expanded up to 4GB. The SO-DIMM modules supported
are 1024MB and 2048MB DDR Modules. The total memory size is automatically detected by the POST routine once
you turn on your computer.
Memory Upgrade Process
1. Turn off the computer, and turn it over and remove the battery (page 2 - 5).
2. Remove screws & from the bottom of the computer.
3. Turn the computer over, open the Lid/LCD, and carefully (a cable is connected to the underside of the LED cover
module) unsnap up the LED cover module from point on the right.
4. Lift up the LED cover module and disconnect the cable .
5. Remove screws - from the keyboard.
Figure 7
RAM-2 Module
Removal
a. Remove the screws
from the bottom of
the computer.
b. Turn the computer
over, open the lid/
LCD and unsnap the
LED cover at point 3.
c. Lift the LED cover
module and discon-
nect the cable.
d. Remove the screws
from the keyboard.

•7 Screws
1
2
3
4
5
6
10
c.
2
1
b.
3
4
5
6 7 98
a.
10
d.