Service manual

Disassembly
Removing the Hard Disk Drive 2 - 9
2.Disassembly
3. Remove the backing from the new protective gasket.
4. Follow the instructions below, depending on which disk you are installing.
If you are replacing a 1.8" hard disk with a 2.5" hard disk:
Stick the 2.5" protective gasket in the appropriate location (Figure 4a).
Insert the 2.5" hard disk into the case, attach it to the connector and replace the mylar case and screws.
If you are replacing a 2.5" hard disk with a 1.8" hard disk:
Place the sponge bottom cover inside the bay.
Stick the 1.8" protective gasket in the location illustrated (Figure 5) as per the approximate dimensions outlined.
Attach the disk to the connector, place the foam top cover inside the bay and replace the case cover and screws.
Figure 5
Changing HDD Sizes
(Cont’d)
b. Stick the gasket in the
appropriate location.
5
6
6
19.0mm
23.0mm
30.70mm
b.