Service manual

Disassembly
2 - 2 Overview
2.Disassembly
NOTE: All disassembly procedures assume that the system is turned OFF, and disconnected from any power supply (the
battery is removed too).
Maintenance Tools
The following tools are recommended when working on the notebook PC:
M3 Philips-head screwdriver
M2.5 Philips-head screwdriver (magnetized)
M2 Philips-head screwdriver
Small flat-head screwdriver
Pair of needle-nose pliers
Anti-static wrist-strap
Connections
Connections within the computer are one of four types:
Locking collar sockets for ribbon connec-
tors
To release these connectors, use a small flat-head screwdriver to gently pry the
locking collar away from its base. When replacing the connection, make sure the
connector is oriented in the same way. The pin1 side is usually not indicated.
Pressure sockets for multi-wire connectors To release this connector type, grasp it at its head and gently rock it from side to
side as you pull it out. Do not pull on the wires themselves. When replacing the
connection, do not try to force it. The socket only fits one way.
Pressure sockets for ribbon connectors To release these connectors, use a small pair of needle-nose pliers to gently lift the
connector away from its socket. When replacing the connection, make sure the
connector is oriented in the same way. The pin1 side is usually not indicated.
Board-to-board or multi-pin sockets To separate the boards, gently rock them from side to side as you pull them apart.
If the connection is very tight, use a small flat-head screwdriver - use just enough
force to start.