Service manual

Disassembly

2 - 8 Removing the System Memory (RAM)

2.Disassembly

Removing the System Memory (RAM)

The computer has two memory sockets for 200 pin Small Outline Dual In-line (SO-DIMM) DDRII (DDR2) type memory

modules. The total memory size is automatically detected by the POST routine once you turn on your computer.

1. Turn off the computer, and turn it over and remove the battery (page 2 - 5).

2. Locate the component bay cover and remove screws

- .

3. Remove the bay cover

4. Gently pull the two release latches( & ) on the sides of the memory socket in the direction indicated by the

arrows.

5. The RAM module(s) will pop-up, and you can then remove it

6. Pull the latches to release the second module if necessary.

7. Insert a new module holding it at about a 30° angle and fit the connectors firmly into the memory slot.

8. The module will only fit one way as defined by its pin alignment. Make sure the module is seated as far into the slot

as it will go. DO NOT FORCE IT; it should fit without much pressure.

9. Press the module down towards the mainboard until the slot levers click into place to secure the module.

10. Replace the bay cover and the screws.

11. Restart the computer to allow the BIOS to register the new memory configuration as it starts up.

Figure 4

RAM Module

Removal

a. Remove the screws.

b. Remove the cover.

c. Pull the release

latch(es).

d. Remove the mod-

ule(s).



Contact Warning

Be careful not to touch

the metal pins on the

module’s connecting

edge. Even the cleanest

hands have oils which

can attract particles, and

degrade the module’s

performance.



14. Component Bay Cover

18. RAM Module

•13 Screws

1 13

16 17

.c.