Service manual

Disassembly
2 - 6 Removing the Hard Disk Drive(s)
2.Disassembly
Removing the Hard Disk Drive(s)
The hard disk drive is mounted in a removable case and can be taken out to accommodate other 2.5" serial (SATA) hard
disk drives with a height of 9.5mm (h). Follow your operating system’s installation instructions, and install all necessary
drivers and utilities (as outlined in Chapter 4 of the User’s Manual) when setting up a new hard disk.
1. Turn off the computer, and turn it over and remove the battery (page 2 - 5).
2. Locate the hard disk bay cover and remove screws - .
3. Remove the bay cover .
4. Slide the hard disk assembly in the direction of the arrow .
5. Remove the hard disk assembly .
6. Remove screws
- and separate the bracket from the hard disk .
Figure 2
HDD Assembly
Removal
a. Remove the screws.
b. Remove the cover.
c. Remove the HDD assem-
bly by sliding it in the di-
rection of the arrow.
d. Remove the screws and
separate the bracket from
the HDD.
1
3
4
5
6
7 10
11 12
4. HDD Bay Cover
11. HDD Bracket
12. HDD
•7 Screws
1 3
4
2
6
5
7
8
9
10
5
6
4
a. d.
b.
c.
11
12