Service manual

Disassembly
2 - 6 Removing the Hard Disk Drive
2.Disassembly
Removing the Hard Disk Drive
The hard disk drive is mounted in a removable case and can be taken out to accommodate other 2.5" serial (SATA II)
hard disk drives with a height of 9.5mm (h). Follow your operating system’s installation instructions, and install all nec-
essary drivers and utilities (as outlined in Chapter 4 of the User’s Manual) when setting up a new hard disk.
Hard Disk Upgrade Process
1. Turn off the computer, and turn it over and remove the battery (page 2 - 5).
2. Locate the hard disk bay cover and remove screws - .
3. Remove the bay cover .
4. Slide the hard disk assembly in the direction of the arrow .
5. Remove the hard disk assembly
(Figure d).
6. Remove screws
- and separate the bracket from the hard disk .
7. Reverse the process to install a new hard disk(s).
Figure 2
HDD Assembly
Removal
a. Remove the screws and
the cover.
b. Remove the cover.
c. Slide the HDD assembly
in the direction of the ar-
row .
d. Remove the HDD assem-
bly .
e. Remove the screws and
separate the bracket from
the HDD.

4. HDD Bay Cover
5. HDD Assembly
11. HDD
•7 Screws
1
3
4
5
6 9 10
11
3
21
9
10
a.
d.
b.
c.
5
7
6
8
11
4
e.