Service manual

2 – 28
2
SERVICE MANUAL
HDD Removal
HARD DISK DRIVE REMOVAL
The HDD is housed in the Base Assembly.
1. Place the LCD PC with its LCD panel facing up and remove Screw A. (Only the LP200ST has this screw.)
2. Remove Screw B.
REMOVING SCREWS A & B
FIG. 2-27
3. Pull the HDD Cartridge out from its bay until the HDD’s connectors are exposed.
4. Separate the HDD Cartridge from the rest of the system by disconnecting the HDD’s Signal Cable (A) and Power Cable (B).
(Both of these cables are a tight fit.)
PULLING THE HDD
CARTRIDGE OUT AND
DISCONNECTING THE HDD
SIGNAL & POWER CABLES
FIG. 2-28
B
A
B
A
B
A