Service manual

2 – 16
2
SERVICE MANUAL
LCD MODULE REMOVAL
Part A
Remove the Back Cover (page 2-4).
Remove the Modem Module (page 2-8).
Remove the I/O Bracket (page 2-13).
Part B
1. Remove 7 screws (A, B, C, D, E, F & G).
2. Disconnect the following 7 cables.
7 Cables
(C1 & C2) The LCD to Inverter Board ( 2 cables from Connector CN2).
(C3) The Right Speaker to System Board (from Connector CN17)
(C4) The Converter Board to LED + Inverter Board (from Connector CN1).
(C5) The LED + Inverter Board to System Board (LED Cable from Connector CN30).
(C6) The LED + Inverter Board to System Board (Inverter Cable from Connector CN31).
(C7) The Left Speaker to System Board (from Connector CN32)
3. Disconnect the following 3 ground wires.
(W1) A ground wire with the LED Cable fixed to the System Board with a screw.
(W2) A ground wire fixed to the Right Speaker with a screw.
(W3) A ground wire fixed to the Left Speaker with a screw.
LCD Module Removal