Service manual

2 – 12

SERVICE MANUAL

INVERTER BOARD REMOVAL

Part A

Remove the Back Cover (Page 2-4).

Part B

1. Remove the Inverter Shielding Plate by removing 3 screws (A, B & C) which secure it to the rest of the system.

(If you have already removed the FDD module, Screws A & B have already been removed during the process.)

2. Remove 2 screws (D & E) which secure the Inverter Board and the Inverter Mylar to the rest of the system.

3. Disconnect the following 3 cables:

(C1 & C2) The LCD to Inverter Board (two cables from Connector CN2).

(C3) The Inverter Board to System Board (from Connector CN1).

4. Separate the Inverter Board and the Inverter Mylar.

REMOVING THE INVERTER

BOARD

FIG. 2-13

Inverter Mylar

Inverter

Shielding

Plate

Inverter Board

Inverter Shielding

Plate

CN1

CN2

FDD Module

Inverter Board Removal