Service manual

Disassembly
Removing and Installing the Processor 2 - 13
2.Disassembly
Processor Installation Procedure
1. Insert the CPU (Figure 9a), pay careful attention to the pin alignment, it will fit only one way (DO NOT FORCE
IT!), and turn the release latch towards the lock symbol (Figure 9b).
2. Remove the stickers (Figure 9c) from the heat sink.
3. Insert the heat sink
as indicated in (Figure 9c).
4. Replace and tighten the screws
- (Figure 9d) in the order indicated on the label.
5. Replace the component bay cover and screws (page 2 - 8).
A
B
C
D
1
6
c.
3
D
b.
2
1
d.
B
A
a.
C
D
Lock
4
5
6
C
Figure 9
Processor
Installation
a. Insert the CPU.
b. Turn the release latch to-
wards the lock symbol.
c. Remove the stickers
from the heat sink and
insert the heat sink.
d. Replace and tighten the
screws in the order indi-
cated on the label.

A. CPU
D. Heat Sink
•6 Screws