Service manual

Disassembly
2 - 20 Removing the CPU
2.Disassembly
Processor Installation Procedure
1. Insert the CPU , paying careful attention to the pin alignment, it will fit only one way (DO NOT FORCE IT!)
(Figure 15a).
2. Press the bracket and latch to lock it.
3. Apply the thermal grease to top of the CPU
(Figure 15b).
4. Insert the heat sink as indicated
(Figure 15c).
5. Tighten screws in the order , , ,
(Figure 15d).
Figure 15
Processor
Installation
a. Insert and lock in the
CPU.
b. Apply thermal grease
to top of the CPU.
c. Insert the heat sink.
d. Tighten the screws in
the order indicated.

A. CPU
E. Heat Sink Unit
6
A
B
C
D
6
E
1
2
3
4
a.
c.
d.
B
D
E
1
2
3
To secure the heat sink unit,
tighten the screws in the order
, , , (there are num-
bers on the heat sink unit itself).
1
2
3
4
4
A
C
b.