Service manual

Introduction
1 - 4 Tilting the LCD Screen & Adjusting the Height
1.Introduction
Tilting the LCD Screen & Adjusting the Height
It is possible to tilt the LCD screen in order to get the best
possible viewing angle of the screen without glare etc.
• Place one hand at the top of the computer , and use the
other to open the stand to an angle of around 15
degrees from the vertical position (the stand will allow
you to adjust to the appropriate angle if you pull it out and
let it spring back).
• Apply pressure with one hand at the top (at point ) of
the computer (while holding on to the side with the other
hand) to carefully push the LCD screen down in order to
tilt it to the appropriate viewing angle (up to 50 degrees
from the vertical position).
• Use one hand at the top of the computer (while holding on
to the side with the other hand) to move the computer back
to the original position
Figure 1
Adjust the Stand/LCD Screen Tilt
15°
1
2
Adjust the stand to tilt
the computer to 15°
from the vertical posi-
tion.
3
50°
50°
Apply pressure from
the top of the screen to
adjust the stand out-
wards (up to 50° from
the vertical position).

Moving the
Computer
We strongly recom-
mend using both hands
to move the computer.
You can use one hand
to grip the computer by
the stand, and the oth-
er to hold the top of the
LCD screen.
It is recommended that
you carry the computer
with the LCD facing
your body to avoid
scratching the surface
against other objects.
However take care not
to scratch the LCD with
any personal items,
belt fittings or jewelry
etc.(one hand gripping
the stand and the other
gripping the top of the
computer to avoid acci-
dentally dropping it).
1
2
3