User`s manual

Chapter 3: BIOS Utilities 2-23
!
!!
!
Setting DIP Switch
Remove the keyboard to reveal the system’s mainboard. Locate the
DIPSwitch (SW1) to set the correct configuration for the following purpose:
Flash ROM BIOS update
To upgrade your computer, you need to keep up with the latest system
BIOS. Consult your dealer for further information. The DIPSwitch needs to
be set in the On position when updating the existing system BIOS. The
DIP Switches should be reset to the Off position after BIOS updating is
complete.
DIP Switch (SW1) Purpose
SW1-1 SW1-2 Flash ROM BIOS
Off Off Existing BIOS
On On Updating BIOS
Accessing DIP Switch (SW1)
1.
Turn the system power off.
2.
Press the two keyboard latches to elevate the keyboard from its normal
position (Figure 2-3).
3.
Carefully lift the keyboard assembly out to expose the mainboard.
Locate the DIPSwitch SW1 to set the configuration (Figure 2-4).