Specifications

5-7
Chapter 5: Installing Drivers
Step VII: ATI DVD Play Driver Installation (Optional)
Note: Firstly make sure that it has already successfully installed the VGA
drivers, Audio Driver and Direct X5 or DirectX6.
m Boot the system, press Ctrl+Alt+S to enter SCU system. Select
[Power]. Enable [Low Power Saving], or Select [Advance CPU
control] to set [Full Speed]. (If the clock of Intel Pentium II is above
366MHz/400MHz or if your DVD runs smoothly, you can skip the
step).
m In the windows system, click [Start]; select [Setting], [Control Panel],
and [System]. Open [Device Manager]; select [CDROM]. Click the
item including the type of [DVD-ROM], and [Setting]; then enable
[DMA] in Options.
m Insert the CD of Ati-DVD-Play applications and the program will
automatically run the installation until finished. Otherwise, click
[Start] in the windows system. Select [Run]. Open the path
[D:\Atiplay\setup.exe ]. Run [setup.exe] to finish the installation.
Step VIII: Using Infrared Wireless Communication
m Please refer to the read-me file under the FIR directory.
Drivers for Windows 98
Step I: VGA Driver Installation
m After installing Win98 successfully, enter into the system. Click
[Start] at the bottom-left corner on the Windows screen; select [Run];
open the path of [D:\WIN9X\setup.exe] to run VGA driver installation.
m When ATI VGA driver has been already included in the system, click
[Start], select [Run] and open the path of [\atiuinst-clean] and double-
click [Ok].
Note: For system ATI VGA included, uninstall the original VGA
Driver and then install the driver.
Step II: Audio Driver Installation
m Under Win98, click [Start] [Settings] [Control Panel] [System].
Open [Device Manager]; select [Other Devices]; press [Remove] to