Installation guide

OS-9 V2.4 on EUROCOM-17 6 Additional Utilities
Software Manual 27
The following streamer types are supported:
mt0.scsi for the Tandberg 3620/40/60 Streamers
mt0.exa for the ExaByte 8200
mt0.teac for the Teac MT-2ST Streamer
mt0.viper for the Archive Viper Tapes
mt0.standard for the WangTek 5150SE and Sankyo CP-150SE
mt0.wang for the WangDat 2600
Default destination device can be set with the shell environment
parameter BACK_DEV, otherwise it is /mt0.
❏ Caveats:
If the source is a saveset, the destination must not be a saveset. If the
output device runs out of free space during a saveset restore operation
back cannot call for a new volume to continue.
There are problems with Tandberg TDC3660 streamers with ROM
Revision4.00 and writing more than one saveset to tape. In some cases
the streamer will hang.
The underscore character '_' is not allowed in saveset name.
Be sure that the specified volume size is smaller than or equal to
volume capacity.
There are two different versions of back, one for old ELTEC drivers and
one for original Microware drivers. At this time Microware drivers are
used on EUROCOM-17 only.
❏ Options:
-s=<filename> Specifies source/destination saveset name for disk.
-t[=<filename>] Specifies source/destination saveset name for tape. If
no filename/device is specified, back uses the default
tape device mt0 and the name save_1.
-i=<date> Only files with a more recent date than specified in
<date> are treated.
Format of <date>: dd.mm.yy[-hh.mm]
i