Installation guide

OS-9 V2.4 on EUROCOM-17 1 Getting Started
Software Manual 1
1 Getting Started
This manual contains informations about the implementation dependent
part of OS-9/68K ELTEC systems.
We recommend, that you are familiar with the following documentations:
• EUROCOM-17 Hardware Manual
• RMon Manual
• OS-9/68K Users Manual
• Using UMACS
1.1 Pre-Installed System
If you have ordered a complete system, the operating system will already
be installed completely on the harddisk, when shipped off. You do not
need the floppy disks delivered with the system and you are also not
concerned with the whole installing procedure (hardware configuration,
formatting, copying, ...) as described in this manual (... until the next OS-9
update arrives).
Only in case of a total crash of the system these disks are used to
reconfigure the system as described - so keep these disks in a save place!
1.2 No Pre-Installed System
If you want to use a serial line terminal, configure it as follows:
9600 baud,
1 start bit,
8 data bits,
1 stop bit,
no parity.
Then connect the RJ11 socket and the terminal I/O socket. Set hex switch
S2 on front panel to 3 for serial I/O with RMon. If you are not using an
ELTEC cable, refer to the hardware manual for correct connection of
signals.