Instruction manual

9
Direct steam nozzle attachment
Use the nozzle attachment to clean places that are not readily
accessible or crevices, for instance.
Scraper attachment
Use the spatula attachment to remove stubborn stains, such as
limescale and deposits.
Circular brush attachment
Use the circular brush attachment to remove stains, for instance
on tiles, heel rims, mirrors and non-cold glass surfaces.
Grout brush attachment
Use the long brush attachment to remove dirt, in grooves and
crevices, for instance.
1. If the base unit is located in the stand on the floor cleaner, push
the unlatching button (1) upwards in order to release the
locking mechanism. Remove the base unit (2) from the stand.
2. Insert the adapter (25) onto the appliance’s steam outlet
nozzle. You must hear it click into place.
3. Select an attachment (see above) and insert it onto the adapter
until it stops. When attached, the flexed end piece of the
appliance (with the exception of the spatula attachment) must
point to the left when the base unit is held with the water tank
facing you.
4. Turn the attachment 90 degrees.
• To remove an attachment from the adapter, turn it back 90
degrees and then pull it off.
• If you want to remove the adapter from the base unit, press on
the adapter’s unlatching lever and remove it from the base unit.
The following attachments belong with the hand steam cleaner:
18. Store the appliance upright in a cool, dry place. To stop the appliance, return it to a vertical
(standing) position. Engage the pivot on the cleaning head and the appliance is locked in place.
19. Before using the appliance again, the water tank should always be checked for any residual
water and, if necessary, completely emptied.
Use the hand steam cleaner
10
❐ Pull the plug out of the plug socket before cleaning.
❐ Never immerse the appliance in water and do not rinse it under running water.
❐ Do not use solvents or abrasive cleaning agents.
❐ The safety of the appliance can only be guaranteed when it is regularly checked for damage and
wear and tear.
❐ Do not use any corrosive or abrasive cleaning agents for cleaning. These could damage
the surface.
• When necessary, wipe the appliance with a damp cloth and possibly some mild
cleaning agent.
• Remove any dirt from the attachments (hairs, fluff etc.)
• The floor cleaning cloth can be washed in a washing machine. It is NOT, however, suitable
for tumble drying.
• Do not put the appliance back in its place until it has completely cooled down and has been
emptied of water.
• Keep the appliance in a dry, clean and cool place which is inaccessible to children.
CAUTION!
Cleaning and storage
5. Move the on/off switch (17) on the back of the appliance to
position 1. The indicator lamp (9) on the front of the appliance
lights up and the appliance heats up.
6. When the appliance has reached its operating temperature,
steam is emitted by pressing the handle of the steam activator
(26). You can now start cleaning.
7. Slowly move the attachment backwards and forwards over the surface to be cleaned and
press the steam activator as required. Hold the attachment for approximately 10 seconds
over areas which need to be cleaned especially thoroughly.
8. When the water tank is empty and steam is no longer being produced, switch the appliance off,
pull the plug out of the plug socket and wait until the appliance has cooled down. Then remove
the water tank and refill it with water (see chapter “Use”, section “Filling the water tank”).
9. If the cleaning process has finished and the appliance has completely cooled down, remove
the water tank, empty it and let it dry.
10. Before using the appliance again, the water tank should always be checked for any residual water
and, if necessary, completely emptied.