User manual

b) Display Measurement with Bluetooth

The app "BTLogger" permits simple display of the measured tem-

perature on a mobile end device, long-term measurement includ-

ing various monitoring functions and data recording of the meas-

ured values. In order to connect the thermo logger to a mobile end

device, proceed as follows:

• Switch on your mobile end device (tablet or smartphone) and

activate the function "Bluetooth

" on that device (see "Settings"

in your mobile end device).

• Tap the app "BTLogger" on your mobile end device to activate it.

• Switch on the thermo logger.

• In the display of the mobile end device, select "Couple new

device".

• Now push the Bluetooth

button on your thermo logger for about

veseconds,asdemandedbytheapp(seetextinthedisplay)

(gure1,item1).OncetheBluetooth

connection has been es-

tablished, this will be displayed by a brief double sound signal

at the thermo logger as well as the display of the connected

device in the app (device type and temperature display). If you

now select the newly coupled device on the display, the app

willswitchtoanewscreen(alsoseegure5).Regardingthis,

observe the following notes in this chapter.

If the connection by Bluetooth

is not established, this

may be due to devices that are located in direct prox-

imity of your devices and also broadcasting using Blue-

tooth

or other devices (such as a router) may act as an

interfering signal. In this case, go elsewhere and start

coupling of the two devices again. It may also be helpful

to remove the battery from the thermo logger for approx.

30 seconds here (reset) or to push the "Reset button" on

therearofthehousing(gure1,item3).