User manual

30
EN
To turn the logo round (solid doors only)
1 Unscrew the screw with a tool Torx T20 screwdriver.
2 Remove the cam.
3 Unscrew the nut with a no. 28 spanner (provided in the accessories
bag).
4 Remove the lock while holding the logo support.
5 Taking care, transfer (to the lock side) the logo support.
6 Remove the logo support.
1I. Reversibility of the lock
Place the lock so that the key hole is vertical, and always
directed downwards.
4
1
2
3
5
6
7 9
7 Gently press the "EuroCave" logo to loosen it from the logo support.
8 Rotate the logo 180° before repositioning it on the logo support.
9 Replace the logo support
10 Replace the lock with the slot vertical and pointing downwards.
11 Tighten the plastic nut first by hand as far as possible, then with a
28 spanner (provided in the accessories bag) maximum 1/2 turn of
the spanner).
12 Attach the cam to the end of the lock with the screw and with a
TX20 Torx spanner supplied in the accessories bag.
4 - INSTALLING YOUR WINE CABINET