Technical data

Issue No.1 Combined Manual 24.10.07

RESTART

- Check there is adequate oil in the storage tank.

- Check oil supply valves are open

- Switch on heating system (e.g. Time Clock)

- Press the Burner Reset Button on the burner Control Box, which will be illuminated. The Burner

Reset Button (illuminated)(Fig 1) will go out and the burner will commence the ignition start

sequence. After 15 seconds the Burner should fire normally.

PLEASE NOTE: Should the Burner not start, the lockout indicator, on the Control Box/Burner Reset

Button will illuminate again.

- Wait at least 3 minutes and press the Burner Reset Button again.

Failure to start a second time indicates a fault requiring attention.

In the event of a second failure to start:

- Switch off electrical supply

- Call service engineer.