OWNER’S MANUAL Garment Steamer Model SC620 RO −P RO EU EURO-PRO Operating LLC 94 Main Mill Street, Door 16 Plattsburgh, NY 12901 1-800-798-7398 www.euro-pro.
IMPORTANT SAFETY INSTRUCTIONS When using your EURO-PRO Garment Steamer, basic safety precautions should always be observed, including the following: 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. To reduce the risk of fire, electric shock, or injury: • Do not leave the Garment Steamer plugged in when unattended. Unplug the electrical cord when not in use and before servicing or refilling water tank. • Do not allow to be used as a toy.
IMPORTANT NOTES DURING OPERATION If steamer hose gurgles during use: • This is a normal result of condensation collecting inside the hose. Simply lift the steam diffuser/handgrip upward until the hose is extended to its full height. • The gurgling will disappear when the excess moisture inside the hose has had a chance to drain back into the base. If the steamer stops producing steam then starts again: • You may wish to examine the inside of the reservoir.
OPERATING INSTRUCTIONS cont. FEATURES OF YOUR GARMENT STEAMER Step 3: Using Garment Steamer cont. 1. The steam diffuser/handgrip at the end of the steamer hose is located just behind the garment brush. By grasping the steam diffuser/handgrip you can aim the direction of the steam released from the nozzle. Caution: The steam hose becomes hot during use. Never hold, pull or move unit by the hose while in use. 2. The garment brush with its small openings is located at the end of the steamer hose.
OPERATING INSTRUCTIONS cont. Preparing Garment Steamer for Use 3. GETTING TO KNOW YOUR GARMENT STEAMER After filling the water bottle, close the cap clockwise. (See fig. 8) CAUTION: Before filling the water tank, check to make sure that the water tank sits securely in the unit before proceeding. Step 1: Preparing for Use 1. 2. 3. 4. Unwind the power cord. Check the wheels to see that they swivel and roll properly. Set the unit on the floor and remove the water tank.
OPERATING INSTRUCTIONS Components 2. Power “On” Light (green): This light will illuminate when the “ON” switch is depressed and the unit is turned on. It will remain on until the unit is turned “OFF” or until the water tank is emptied. Caution: Always unplug before refilling. OPERATING INSTRUCTIONS cont. To assemble the garment rod, insert one of the extensions into the other by depressing the button on the extension (marked C) so that you can insert into the other extension (marked D).
