OWNER’S MANUAL Model: IR577P 120V., 60 Hz., 1700 Watts EURO-PRO Operating LLC U.S.: 94 Main Mill Street, Door 16 Canada : 4400 Bois-Franc Plattsburgh, NY 12901 St-Laurent, QC H4S 1A7 Tel. : 1 (800) 798-7398 www.euro-pro.com.
IMPORTANT SAFETY INSTRUCTIONS When using your iron, basic safety precautions should always be followed, including the following: 1. Read all instructions carefully. 14. CAUTION: TO AVOID FIRE, never 2. Use iron only for its intended use. leave iron unattended while it is 3. To protect against risk of electrical shock, plugged in. do not immerse the iron in water or other 15. CAUTION: TO PREVENT ELECTRIC liquids. SHOCK, never use the iron in a 4. Never yank cord to disconnect from outlet.
TROUBLESHOOTING PROBLEM Iron does not heat Some odor or small particles come out of steam vents of new iron Iron does not steam Water droplets coming from steam vents POSSIBLE REASONS & SOLUTIONS • Iron should be plugged into a 120V AC electrical outlet only. Make sure that the plug is securely in the socket. • Fabric/temperature setting too low. Select a higher fabric/temperature setting. • This is normal.
FEATURES OF RETRACTORTM IRON LED Display Panel NOTE: Always refer to the garment care tag for ironing instructions. Before starting to iron delicate fabrics, it is best to first test the temperature of the iron on a hem or an inside seam. 3 2 IRONING CHART 1 DIRECTIONS ON LABEL Burst of steam provides extra, sudden bursts of steam which aid in removing stubborn wrinkles from fabrics such as denim, cotton or linen. FABRIC SYNTHETIC FIBERS, e.g. acrylic, nylon polyester 7.
OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS Note: Because of the soleplate design, ordinary tap water may be used with this iron. However, in very hard water areas, we recommend using distilled or demineralized water. This appliance is for HOUSEHOLD USE ONLY and may be plugged into any 120V AC polarized electrical outlet. Do not use any other type of outlet. Emptying the Iron 1. Always empty iron after each use. 2.
OPERATING INSTRUCTIONS 4. Place the iron on its heel on a stable, protected surface and allow the iron to heat for approximately two (2) minutes or until the temperature settings on the right side of the LED display panel have stopped flashing. 5. Slide the variable steam control to the right to increase the amount of steam. When using extra steam, the iron uses more water and it may be necessary to fill the water tank more often. (Fig. 2) OPERATING INSTRUCTIONS Selecting Iron Temperatures Slide Fig.
