User manual

I771 Motherboard User Manual
6
Chapter 2 Installations
2.1 Memory Module（DIMM）Installation
I771 motherboard supports dual DDR2 memory socket for a maximum total memory
of 4GB in DDR2 memory type.
2.1.1 Installing and Removing Memory Modules
To install the DDR 2 modules, locate the memory slot on the board and per form the
following steps:
1. Hold the DDR2 module so that the key of the DDR 2 module align with those on
the memory slot.
2. Gently push the DDR 2 module in an upright position until the clips of the slot
close to hold the DDR 2 module in place when the DDR 2 module touches the
bottom of the slot.
3. To remove the DDR 2 module, press the clips with both hands.
DDR2 Module
Lock Lock
Lock Lock
2.2 I/O Equipment Installation
2.2.1 12V DC-IN
The Motherboard allows plugging 12V DC-IN jack on the board without another
power module converter under power consumption by Intel Socket P processor in
GM45 with ICH9M-E chipset.
2.2.2 PS/2 Keyboard and PS/2 Mouse
The Motherboard provides two PS/2 interface. The PS/2 connector supports Keyboard
and Mouse. In other cases, especially in embedded applications, a mouse is not use d.
Therefore, the BIOS standard setup menu allows you to select* “All, But Keyboard”