Product Manual

Instructions for converting the main burners
1. Unscrew and remove the rear panel pictured.
2. Unscrew the main burner securing screws and remove the burner, sitting it alongside.
3. With the burner removed, you will see the brass gas jet which is screwed into the end of the valve. Using
the socket driver supplied, unscrew the end LPG jet while retaining the inner (NG) jet.
4. Reassemble the burner.
Note: Please make sure the gas valve is located well inside the main burner tube when re-installing the burners.
5. Repeat the above steps for the other main burners