Heavy Duty Upright Vacuum Cleaner Ownerʼs Guide HD4570 Series Index Important Safeguards .............2 Service Information ................4 Assembly .............................5-6 Use .........................................7 Thermal Cut Off ............... 4 & 7 Accessories ............................8 Brush Roll ...............................9 Brush Roll Belt ...................9-10 Dust Bag ..........................10-11 Hose Blockage ................12-13 Filters ...............................
IMPORTANT SAFEGUARDS When using an electrical appliance, basic precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER. WARNING To reduce the risk of fire, electric shock, or injury: • Do not use outdoors or on wet surfaces. • This appliance is provided with double insulation. Use only identical replacement parts. See instructions for Servicing of Double-Insulated Appliances. • Do not leave vacuum cleaner when plugged in.
CONSEILS DE SÉCURITÉ Lors de lʼutilisation dʼun appareil électrique, quelques précautions élémentaires doivent être observées, incluant les suivantes: LISEZ TOUTES LES INSTRUCTIONS AVANT DʼUTILISER VOTRE ASPIRATEUR. AVERTISSEMENT Pour réduire le risque de feu, de choc électrique, ou de blessure: • Ne pas utiliser à lʼextérieur ou sur des surfaces mouillées. • Cet appareil est muni dʼun double-isolement. Utilisez uniquement des pièces de rechange identiques.
SERVICING OF DOUBLE-INSULATED APPLIANCES A double-insulated appliance is marked with one or more of the following: The words “DOUBLE INSULATION” or “DOUBLE INSULATED” or the double insulation symbol (square within a square). In a double-insulated appliance, two systems of insulation are provided instead of grounding. No grounding means is provided on a double-insulated appliance, nor should a means for grounding be added to the appliance.
HOW TO ASSEMBLE CAUTION: Moving parts, make sure on/off switch is in off position before plugging in. CAUTION: Assemble the cleaner before using. NOTE: Features may vary by model yet all parts assemble the same. Step A Attach Handle Step B Attach Hose CAUTION: Do not catch cord under handle. 2 Tab 3 Ledge 1 Groove 2 1 Groove Electrical Cord 3 1. Before placing the front cover on the unit, install the hose. 1. From rear of cleaner, align handle with groove and slide onto cleaner.
Step C Check Disposable Dust Bag Step D Store Hose and Accessories 1 Hose Adapter Dusting Brush Upholstery Tool Paper Bag Collar 1. Check to be sure the paper bag collar is secure with the hose adapter inside the paper bag collar. Crevice Tool Carrying Handle Telescoping Wand Hose Retainer Step E Store Electrical Cord 2. Replace front bag cover. Place the tabs on the bag cover in the slots at the bottom of the bag compartment.
HOW TO USE The upright vacuum cleaner design allows use on multiple types of carpeting and on upholstery or bare floors with attachments. When using the attachment tools, place the handle in the upright position. Do not place cleaner on furniture or steps as the brush roll may cause damage. 4 ON/OFF 1. Adjust cleaner height setting knob to lowest position for maximum cleaning. Adjust to a higher setting to make pushing easier. For easy adjustments, tilt the cleaner back to move the knob. 2.
How To Use Accessories NOTE: Do not place cleaner on furniture or steps as the brush roll may cause damage. Place cleaner on floor with the handle in storage position while using accessories. Crevice Tool cleans corners, baseboards, between cushions, sliding door tracks. 1. Remove hose from rear of cleaner. 2. Place desired accessory onto end of hose or wand. Dusting Brush is for furniture, blinds, books, lamp shades, shelves. Upholstery Nozzle is for curtains, draperies, cushions, fabrics.
HOW TO MAINTAIN The instructions in this booklet serve as a guide to routine maintenance. To avoid unnecessary service calls, check the bag, belt, and brush roll often. Brush Roll The brush roll turns as it sweeps and combs the carpet nap. Remove hair and threads from the brush roll so it continues brushing the carpet. To maintain the most efficient cleaning, the bristles must touch the carpet. To test the bristle length, hold a ruler against the underneath side of the cleaner.
5 8 5. Place new belt around motor pulley. 8. Pull right side of brush roll to stretch belt. Secure right end cap into base. 7 6 9 Left Side View 9. Rotate brush roll to seat belt. 6. Place belt around brush roll. 7. Align left end cap with square in base. Push end cap into place; see left side view. 10. Replace the hood. Make sure hood front is behind furniture guard. Hood should seat onto self-locating fastener tabs. 11. Turn fasteners 1/4 turn to lock.
How To Replace Bags–Style AA NOTE: Turn off the switch and unplug the electrical cord before changing dust bag. Never operate the vacuum cleaner without the dust bag or the filter. To Remove Bag: Front Cover Latch B A Front Cover A. Remove front cover by pulling out on the front cover latch and lifting the front cover upward and out. To Replace New Bag: B. Remove left side of bag collar from bag collar retainer. Grasp bag collar; pull down slightly and out to remove bag. F C.
How to Check and Clear Hose Blockages Low suction or poor pickup may be due to a blockage in the vacuum cleaner. 1. Remove hose and check suction at end of hose - if little or no suction, check disposable dust bag. Change if needed. If no improvement proceed to Step 2. NOTE: Turn off the switch and unplug the electrical cord before clearing hose. 2. Remove the front bag cover. To remove hose adapter from opening, twist hose adapter clockwise and lift upward.
How to Check and Clear Blockages in Base 1. Remove the attachment hose from the lower hose retainer and look into the hose retainer for any obstructions. Proceed to Step 2 to check for any other blockages. 2. Remove the hood by loosening the two fasteners located on the top of the hood and lifting upward. These fasteners need only a quarter turn to lock or unlock the hood. (See padlock graphics on the hood.
Motor Filter Check the motor filter with each disposable dust bag change. Clean or replace as needed. 3 To Clean Motor Filter Back Ledge 1. Remove filter from inside bag compartment, lower left side. 2. Shake filter or vacuum with another cleaner to remove excess dust. 3 Filter Retainer 3. Reinstall filter. Slide under back ledge and filter retainer. Install with colored/smooth side down. 1 and 3 HEPA Filter Check the HEPA filter with each disposable dust bag change. Replace twice a year or as needed.
How To Change Light Bulb (only for models with a headlight) NOTE: Turn off the power switch and disconnect the electrical cord before changing light bulb. 1. Lower handle to remove two screws from lens cover. 2. Pull lens cover from cleaner. 1 3. Support socket with one hand and push light bulb into socket; turn to release. 4. Place new light bulb into socket; turn to secure. 5. Push light bulb and socket back so bulb will not touch lens cover. 6. Replace lens cover. 4 7. Secure with two screws.
PROBLEM SOLVING NOTE: Turn off the switch and unplug the electrical cord before servicing. PROBLEM CAUSE SOLUTION Motor will not start. ✓ Electric Plug Push plug securely into outlet. Try another outlet. Check circuit breaker. Motor suddenly stops. ✓ Thermal Cut Off Refer to page 7. Does not clean the carpet or floor. ✓ Disposable Dust Bag Change the bag and clean or replace the filter(s).
THE EUREKA® HD 2 YEAR LIMITED WARRANTY WHAT THIS WARRANTY COVERS Your Eureka HD cleaner is warranted to be free from all defects in material and workmanship in normal use FOR A PERIOD OF TWO YEARS. The warranty is granted only to the original purchaser of the cleaner. The warranty is subject to the following provisions. • • • WHAT THIS WARRANTY DOES NOT COVER Parts of the cleaner that require replacement under normal use, such as bumpers, bags, bristle strips, belts, light bulbs, hoses, and impellers.
REPAIR PARTS LIST HD4570A Eureka Heavy Duty THE EUREKA COMPANY BLOOMINGTON, IL 61701 4/7/04
2 19
HD4570A 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. 17. 18. 19. 20. 21. 22. 23. 24. 25. 26. 27. 28.
4 21
HD4570A 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. 17. 18. 19. 20. 21. 22. 23. 24. 25. 26. 27. 28. 29. 30. 31. 32.
6 23
HD4570A 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. 17. 18. 19. 20. 21. 22. 23.
8 25
HD4570A 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12.
10 27
Assembly Items in This Carton 1 crevice tool 1 hardware package (2 screws) 1 dusting brush 1 hose adapter w/hose 1 telescoping wand 1 cleaner connected to handle by cord 1 upholstery brush 1 front cover Thank you for selecting a Eureka cleaner. Donʼt Forget to Use Genuine Eureka Bags and Belts Caution: Damages caused by the use of nongenuine Eureka bags are not covered by The Eureka Heavy Duty Limited Warranty. Part No. 74339 (3/04) ©2004 Electrolux Home Care Products, Ltd. Printed in U.S.A.
