Instructions

4
Charging the Tag – fold down the protective dustcover on the tag and insert
the rectangular micro USB connector into the charging port. The USB symbol
should be facing up as shown in Figure 3. The USB connector on the other end
of the cable can be connected to the supplied AC adapter or to any powered
USB source, such as a computer, auto adapter, rechargeable battery pack, etc.
Although the tag will charge when turned on or off, if you turn it on you can
see the charging status. To turn the tag on, press and hold the blue power
button until the red light begins to flash. The tag’s status light will flash once
per second until the charge cycle is complete and then the light will briefly
flash once every 10-seconds. The tag will not communicate with the locator
while charging is in process. Charging a completely discharged battery will
take 2 to 3 hours, partial charging can take much less time. Make certain to
securely replace the protective rubber cover after charging to keep dirt and
debris out of the connector - the rubber cover has nothing to do with the
waterproofing of the tag.
Charging the Locator – insert the round charging plug into the connector
marked “Power” on the front of the locator. The USB connector on the other
end of the cable can be connected to the supplied AC adapter or to any
powered USB source, such as a computer, auto adapter, rechargeable battery
Insert Connector with
Symbol Facing Up
Charging Jacks
Figure 3
Location of Charging
Jacks
Fold Down Dust
Cover