Data Sheet

6
Labeling the Tag Buttons
To help remember which objects are assigned to which of the three Tag buttons
on the locator, you may fill in the included tag button labels and place them in
the label wells under each button. You may wish to abbreviate the objects
description to write on the small label.
Rescue Group Searching
One locator can teach a single Tag ID to any number of other locators – even if
the object is lost and you do not have access to the tag. This is useful if two or
more searchers will be looking for the same lost object. To do this, put the
second locator (the one receiving the Tag ID) into Learn Mode, just as you would
in the pairing operation above, then within 20 seconds turn on the first locator,
the one that has the ID you wish to transfer. The first locator will now prompt
you for which of the 3 Tag ID’s you want to transfer by flashing its 3 select
boxes. Press the Tag button that you wish to transfer to the second locator; the
second locator should beep twice to indicate it has received the ID. Note that the
locator receiving the Tag ID does not have to use the same Tag button
assignment as the locator sending the ID. For example, your lost tag may be
assigned to Tag 1 on your locator but your friend may wish to transfer that Tag
ID into Tag 2 or 3 on their locator. You may repeat this operation with any
number of locators, one at a time.
Flashing
Figure 5
Learn Mode Display
(Tag 2 Shown as an Example)