Data Sheet

16
condominium with a small outside area. This does not mean that an
alarm will necessarily sound when the tag is moved just outside of the
area; it is just the smallest boundary that is practical to set without
receiving false alarms.
Medium - This setting will work for most homes with two stories and a
medium to large yard area. This is the factory default setting.
Far - This setting is for homes with very large yards or yards with
obstructions, hills, etc. that may block the signals from the tag.
Max - In this mode the locator must lose communications with the tag to
activate an alarm. Use this setting in very large areas or in urban settings
where large buildings may block the signals from the tag.
Once you have made your boundary selection, press the Select button to store
your settings and exit setup mode. If you have more than one tag you wish to
monitor then repeat the setup process for each tag. The monitoring setups are
stored permanently in the locator and will not be lost even if the battery is
removed.
Monitoring a Single Tag
To begin monitoring the tag and receive alarm notifications if they move outside
of your selected boundary area, press the Tag button over the desired object’s
description twice. This will cause the word Monitor to flash. You can press
Select to start monitor mode immediately or simply wait 5 seconds and the
locator will enter monitoring mode automatically. Once the monitoring mode has
been started the display will appear as shown in Figure 13.
Figure 13
Starting Monitor Mode
Flashing