Data Sheet

15
Press the Down Arrow button to cycle through the alarm mode selections:
On - When the tag is found outside of the designated area for 2 consecutive
monitoring checks (40 to 80 seconds) an audible tone is generated by the
locator.
Remote - An audible tone is generated by the locator plus, after an
additional monitoring check shows the tag is still outside the designated
area, the external alarm output is activated. Please check
eurekaproducts.com to see the available accessory devices that can be
used with this output.
Off - Only the ALARM indication is shown on the locator’s display. No
audible or external alarm is generated.
Once you have made your alarm mode selection, press the Select button, the
display will now show the last stored (or factory default) boundary selection as
shown in Figure 12.
Press the Down Arrow button to cycle though the boundary selections. In general,
you want to choose the smallest boundary area that does not generate false
alarms as the tag and people/other objects are moved about within the boundary
area. These are the available boundary selections:
Near - Used when the tag is intended to be very close to the locator at all
times. Examples would include an object that should remain indoors in a
small to medium sized home, an RV, campsite, cabin or other fairly
confined area. This setting may also be suitable for a patio home or
Flashing
Figure 12
Setting Monitor Boundary for Tag 1