Data Sheet

ManualsBrandsEureka Technology ManualsUAV & Drone Safety / Recovery SystemsMarco Polo Advanced Single RC Aircraft Recovery System

Monitoring Mode Setup

Monitoring Multiple Tags

Monitoring a Single Tag

Selecting the Tag

Entering Setup

Selecting the Alarm Mode

Selecting the Boundary

Displaying Tag 1’s Status

Displaying Tag 2’s Status

Monitoring Display

Alarm Display

 Press and hold the Select

button until Setup is flashing.

 Press Select again to enter

setup, all 3 mode boxes will

now flash.

 Press the Tag button for the

tag you wish to setup.

 Press Down to select the

desired alarm mode and

then press select.

 Press the Down button to

select the desired boundary

and press Select to exit

setup.

Alarm Modes:

 On - Beeper sounds

 Remote - Beeper sounds and the external

alarm output is activated.

 Off - No beeper, display only.

Boundary Settings:

 Near - Small yard, RV, campsite.

 Med - Average backyard

 Far - Large property or many obstructions.

 Max - Must lose contact to activate alarm.

 The Marco Polo system can monitor up to 3 tags at one time.

 Simply repeat the process under “Monitoring a Single Tag”

for each tag to be monitored, wait for searching to complete

before going on to the next tag.

 Each tag’s proximity is checked once every 40 seconds.

 The display will switch once every 7 seconds to show the

most recent information for that tag.

 If any tag is outside its defined boundary an alarm will sound

and “Alarm” will be displayed for each out-of-bounds tag.

Switching Between Modes

 Each of the 3 tag channels can be switched between track,

monitor or idle (blank) modes by pressing the Tag button

until the desired mode is flashing and then by pressing Select.

 Mode switching can take up to 40 seconds depending on the

current mode and the new selected mode.

 Only one tag may be in track mode at a time.

Nighttime and Hands-Free Searching

 A short press of the locator’s power button will turn the

backlight on or off for searching at night.

 When searching while driving the locator can be set to search

mode and placed on the seat, when the locator begins beeping

once every 5 seconds the tag is within range.

Eureka Technology Partners, LLC

Toll Free: (866) 825-4208

www.eurekaproducts.com

Protected under the following US and Foreign Patents: US 6,788,199 US 7,148,801 CA 2438172 AU 2002255750

Flashing

 If the tag is outside the

selected boundary on two

consecutive checks the

alarm is activated.

 Cancel by pressing the Tag

button to enter track or idle

or press Down to silence.

 Once every 40 seconds the

locator will compare the

tag’s location to the selected

boundary and update its

status on the display.

 Press the Tag button 1, 2 or

3 twice for the desired tag

and then press Select to

enter monitor mode.

 “Searching” will flash while

the locator establishes

communications with the

tag.