User Guide

ManualsBrandsEureka Technology ManualsPet Tracking & EntertainmentMarco Polo Advanced Single Pet Tracking System

Monitoring Mode Setup

Monitoring Multiple Pets

Monitoring a Single Pet

Selecting the Pet

Entering Setup

Selecting the Alarm Mode

Selecting the Boundary

Displaying Pet 1’s Status

Displaying Pet 2’s Status

Monitoring Display

Alarm Display

 Press and hold the Select

button until Setup is flashing.

 Press Select again to enter

setup, all 3 mode boxes will

now flash.

 Press the Pet button for the

pet you wish to setup.

 Press Down to select the

desired alarm mode and

then press select.

 Press the Down button to

select the desired boundary

and press Select to exit

setup.

Alarm Modes:

 On - Beeper sounds

 Remote - Beeper sounds and the external

alarm output is activated.

 Off - No beeper, display only.

Boundary Settings:

 Near - Inside pets, small yard, RV, campsite.

 Med - Average backyard

 Far - Large property or many obstructions.

 Max - Must lose contact to activate alarm.

 The Marco Polo system can monitor up to 3 pets at one time.

 Simply repeat the process under “Monitoring a Single Pet”

for each pet to be monitored, wait for searching to complete

before going on to the next pet.

 Each pet’s location is checked once every 40 seconds.

 The display will switch once every 7 seconds to show the

most recent information for that pet.

 If any pet is outside its defined boundary an alarm will sound

and “Alarm” will be displayed for each wandering pet.

Switching Between Modes

 Each of the 3 pet channels can be switched between track,

monitor or idle (blank) modes by pressing the Pet button until

the desired mode is flashing and then by pressing Select.

 Mode switching can take up to 40 seconds depending on the

current mode and the new selected mode.

 Only one pet may be in track mode at a time.

Nighttime and Hands-Free Searching

 A short press of the locator’s power button will turn the

backlight on or off for searching at night.

 When searching while driving the locator can be set to search

mode and placed on the seat, when the locator begins beeping

once every 5 seconds the pet is within range.

Eureka Technology Partners, LLC

Toll Free: (866) 825-4208

www.eurekaproducts.com

Protected under the following US and Foreign Patents: US 6,788,199 US 7,148,801 CA 2438172 AU 2002255750

Flashing

 If your pet is outside the

selected boundary on two

consecutive checks the

alarm is activated.

 Cancel by pressing the Pet

button to enter track or idle

or press Down to silence.

 Once every 40 seconds the

locator will compare your

pet’s location to the selected

boundary and update its

status on the display.

 Press the Pet button 1, 2 or 3

twice for the desired pet and

then press Select to enter

monitor mode.

 “Searching” will flash while

the locator establishes

communications with your

pet’s tag.