Instructions

11
Tracking
Once the searching operation has been successful the tracking display will
appear as shown in Figure 8.
When the tracking mode is activated the locator communicates with your pet’s
tag about once every 5 seconds. When your pet’s tag responds, the following
information is updated on the display:
1. The “tag” icon flashes to show that your pet’s tag responded to the
locator.
2. The signal strength received from the tag is measured and converted to
a percentage that ranges from 0% to 99%. 99% means you are very
near your pet, 0% means you are far away.
3. The signal strength received from the tag is also displayed as a number
of “bars” (like the signal strength bars on your cell phone). The more
bars that are showing the closer you are to your pet.
4. If the locator is in an area where there are not too many obstructions, a
directional arrow will display showing the direction of your pet.
In addition to the displayed information listed above, the locator will sound a
number of beeps each time your pet’s tag responds. A single beep means that
your pet is not in the immediate vicinity, two beeps means fairly close and
three beeps indicate the pet is in close proximity. You can use this audible
feedback for hands free searching while driving or to allow you to concentrate
Tag Icon Flashes Each Time
the Pet’s Tag Responds
Signal Strength
Percentage
(Higher = Closer)
Range Bars
(More Bars = Closer)
Directional Arrow Points in
the Direction of Your Pet
Figure 8
Tracking Display