Instructions

8
Labeling the Pet Buttons
To help remember which pets are assigned to which of the three Pet buttons on
the locator, you may fill in the included pet button labels and place them in the
label wells under each button. You may wish to abbreviate the pet’s name or
just use the first letter of the name to write on the label.
Rescue Group Searching
One locator can teach a single Tag ID to any number of other locators – even if
the pet is lost and you do not have access to the tag. This is useful if two or
more searchers will be looking for the same lost pet. To do this, put the second
locator (the one receiving the Tag ID) into Learn Mode, just as you would in
the pairing operation above, then within 20 seconds turn on the first locator,
the one that has the ID you wish to transfer. The first locator will now prompt
you for which of the 3 Pet ID’s you want to transfer by flashing its 3 select
boxes. Press the Pet button that you wish to transfer to the second locator; the
second locator should beep twice to indicate it has received the ID. You may
repeat this operation with any number of locators, one at a time. Note that the
locator receiving the Tag ID does not have to use the same Pet button
assignment as the locator sending the ID. For example, your lost pet may be
assigned to Pet 1 on your locator but your friend may wish to transfer that Tag
ID into Pet 2 or 3 on their locator.
Backlight
Each time you press a button on the locator the display’s backlight will come
on for 5 seconds. A short press of the Down Arrow button can be used to turn
on the backlight for 5 seconds when needed without affecting the search or
tracking functions. If you need the backlight to be on for a more extended time,
short presses of the Power button will latch the backlight on or off. Keep in
mind that using the backlight for extended periods will shorten the battery life
of the locator considerably.
Sounds
The locator sounds various beep tones to indicate key presses, range
indications, monitor alarms and error conditions. To silence all beep tones,
press and hold the Down Arrow button on the locator for 2 seconds - the
display backlight will come on to indicate you have held the button long
enough. To reactivate the beep tones, press and hold the Down Arrow button
again. Note: audible alarms for monitoring may also be individually configured